SFI SYSTEM(w/ Canister Pump Module), Diagnostic DTC:P060A

DTC Code DTC Name
P060A Internal Control Module Monitoring Processor Performance

MONITOR DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, the DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P060A Internal Control Module Monitoring Processor Performance

A CPU reset is performed after one of the following conditions is met (1 trip detection logic):


  • There is an ECM main CPU error.

  • There is an ECM sub CPU error.

  • There is an electronic throttle monitoring CPU error.

 ECM Comes on DTC stored

MONITOR STRATEGY

Required Sensors/Components ECM
Frequency of Operation Continuous

CONFIRMATION DRIVING PATTERN


  1. Turn the ignition switch off.

  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  3. Connect the cable to the negative (-) battery terminal.

  4. Turn the ignition switch to ON and wait for 16 seconds or more.

CAUTION / NOTICE / HINT

Tech Tips

Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. READ OUTPUT DTC (DTC P060A)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Clear the DTCs.

      Click here


      Powertrain > Engine and ECT > Clear DTCs

    5. Turn the ignition switch off and turn the GTS off.

    6. Disconnect the GTS.

    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    8. Connect the cable to the battery negative (-) battery terminal.

    9. Connect the GTS to the DLC3.

    10. Turn the ignition switch to ON.

    11. Turn the GTS on.

    12. Wait 16 seconds or more.

    13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    14. Read the DTCs.


      Powertrain > Engine and ECT > Trouble Codes
      Result
      Result Proceed to
      DTC is not output A
      DTC P060A is output B

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

    B

    REPLACE ECM Click here