ECD SYSTEM, Diagnostic DTC:P0606, P060A, P060B, P1607

DTC Code DTC Name
P0606 ECM / PCM Processor
P060A Internal Control Module Monitoring Processor Performance
P060B Internal Control Module A/D Processing Performance
P1607 Cruise Control Input Processor

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0606 ECM / PCM Processor ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
P060A Internal Control Module Monitoring Processor Performance ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
P060B Internal Control Module A/D Processing Performance ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
P1607 Cruise Control Input Processor ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P0606 Ignition switch ON for 1 second
P060A
P060B
P1607

CAUTION / NOTICE / HINT

Note

After replacing the ECM, the new ECM needs registration (Click here ) and initialization Click here.

Tech Tips

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK WHETHER DTC OUTPUT RECURS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.


      Powertrain > Engine > Clear DTCs

    4. Turn the ignition switch off for 30 seconds or more.

    5. Turn the ignition switch to ON for 1 second.

    6. Enter the following menus: Powertrain / Engine / Trouble Codes.


      Powertrain > Engine > Trouble Codes

    7. Read the DTCs.

      Result
      Proceed to
      DTC P0606, P060A, P060B and/or P1607 is output
      DTC is not output

    DTC is not output

    CHECK FOR INTERMITTENT PROBLEMS Click here

    DTC P0606, P060A, P060B and/or P1607 is output

  2. REPLACE ECM


    1. Replace the ECM.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Clear the DTCs.


      Powertrain > Engine > Clear DTCs

    5. Turn the ignition switch off for 30 seconds or more.

    6. Turn the ignition switch to ON for 1 second.

    7. Enter the following menus: Powertrain / Engine / Trouble Codes.


      Powertrain > Engine > Trouble Codes

    8. Confirm that the DTC is not output again.

      Result
      Proceed to
      NEXT

    NEXT

    END