LIGHTING (INT) SERVICE DATA

PERSONAL LIGHT
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected 1 (+B1) - 20 (GND) Map light switch LH OFF 10 kΩ or higher
Map light switch LH ON Below 1 Ω
Map light switch RH OFF 10 kΩ or higher
Map light switch RH ON Below 1 Ω
1 (+B1) - 18 (CTY) Courtesy switch OFF position 10 kΩ or higher
Courtesy switch DOOR position Below 1 Ω
FRONT DOOR COURTESY SWITCH
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected Terminal 1 - Switch body Pushed 10 kΩ or higher
Not pushed Below 1 Ω
REAR DOOR COURTESY SWITCH
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected Terminal 1 - Switch body Pushed 10 kΩ or higher
Not pushed Below 1 Ω
BACK DOOR COURTESY SWITCH (w/o Power Back Door)
Connector Condition Tester Connection Condition Specified Condition
Component with harness connected 2 (ACT-) - 3 (D+) Close 10 kΩ or higher
Open Below 1 Ω
BACK DOOR COURTESY SWITCH (w/ Power Back Door)
Connector Condition Tester Connection Condition Specified Condition
Component with harness connected 3 (CLS) - 1 (E) Open position Below 1 Ω
Open position → Half-latch position Below 1 Ω → 10 kΩ or higher
Half-latch position 10 kΩ or higher
Full-latch position 10 kΩ or higher
Overstroke position 10 kΩ or higher
1 (E) - 4 (CTY) Open position Below 1 Ω
Half-latch position Below 1 Ω
Half-latch position → Full-latch position Below 1 Ω → 10 kΩ or higher
Full-latch position 10 kΩ or higher
Overstroke position 10 kΩ or higher
2 (FSW) - 1 (E) Open position 10 kΩ or higher
Open position → Half-latch position 10 kΩ or higher → Below 1 Ω → 10 kΩ or higher
Half-latch position 10 kΩ or higher
Half-latch position → Full-latch position 10 kΩ or higher → Below 1 Ω → 10 kΩ or higher
Full-latch position 10 kΩ or higher
Overstroke position 10 kΩ or higher
6 (OPN) - 1 (E)

Sector gear in neutral position

(Sector switch on)

Below 1 Ω

Sector gear not in neutral position

(Sector switch off)

10 kΩ or higher
RELAY
Connector Condition Tester Connection Condition Specified Condition
- 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω