ГИДРОАККУМУЛЯТОР ПРИВОДА СЦЕПЛЕНИЯ (для EC69) УСТАНОВКА

PROCEDURE


  1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY


    1. Install the clutch accumulator assembly to the manual transaxle assembly with the 3 bolts.

      Torque:
      11.8 N*m  { 120 kgf*cm, 9 ft.*lbf }
    2. A012IDBN01

      Temporarily tighten the bleeder to accumulator tube and accumulator to flexible hose tube (B).

    3. Install the clutch hose with a new clip (C).

    4. Using a 10 mm union nut wrench, install the bleeder to accumulator tube and accumulator to flexible hose tube to the clutch accumulator assembly (B).

      Torque:
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

        Click here

    5. Connect the clutch line clamp to the manual transaxle assembly with the bolt (A).

      Torque:
      11.8 N*m  { 120 kgf*cm, 9 ft.*lbf }

  2. FILL RESERVOIR WITH BRAKE FLUID

    Click here

  3. BLEED CLUTCH LINE

    Click here

  4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here

  5. INSPECT FOR FLUID LEAK

    Tech Tips

    Check for leaks in the clutch system.

  6. INSTALL NO. 2 BATTERY CARRIER

    Click here

  7. INSTALL BATTERY

    Click here

  8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  10. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  11. INSTALL NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  12. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here