МАСЛЯНЫЙ НАСОС В СБОРЕ (для моделей с 8NR-FTS) СНЯТИЕ

PROCEDURE

1. Click here

   REMOVE NO. 1 ENGINE UNDER COVER

   Click here

2. Click here

   DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

   Click here

3. Click here

   REMOVE FRONT ENGINE MOUNTING INSULATOR

   
   
   1. 

      Remove the bolt and nut, and separate the front engine mounting insulator from the front engine mounting bracket.

   2. 

      Remove the 2 bolts and front engine mounting insulator from the front crossmember sub-assembly.

4. Click here

   REMOVE FRONT ENGINE MOUNTING BRACKET

   Click here

5. Click here

   REMOVE OIL PUMP WITH MOTOR ASSEMBLY

   
   
   1. 

      Disconnect the oil pump with motor assembly connector.

   2. Remove the bolt and disconnect the wire harness from the oil pump with motor assembly.

   3. 

      Remove the 3 bolts and oil pump with motor assembly from the continuously variable transaxle assembly.

      Note:

      The O-ring of the oil pump with motor assembly is not available as a supply part. As the O-ring is a non-reusable part, if the oil pump with motor assembly is removed, the oil pump with motor assembly must be replaced with a new one.