СТАРТЕР (для моделей без системы запуска и останова) УСТАНОВКА

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Close the terminal cap.

    4. Connect the starter assembly connector.

    5. B0043X2

      Install the terminal cap protector to the terminal cap and secure it with the clamp.

      Note


      • Make sure the claw makes a click sound, indicating that it fits tightly.

      • Replace the terminal cap protector with a new one if the claw does not fit tightly or is deformed.

  2. INSTALL FLYWHEEL HOUSING SIDE COVER


    1. B0041W0C01
      *a Protrusion

      Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.

      Note


      • Make sure the claw makes a click sound, indicating that it fits tightly.

      • Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.

  3. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here