ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ СНЯТИЕ

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. REMOVE BATTERY

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. REMOVE NO. 1 AIR TUBE


    1. A012MGH

      Disconnect the 2 wire harness clamps from the manual transaxle assembly.

    2. Remove the 4 bolts.

    3. Loosen the 2 hose clamps and remove the No. 1 air tube.

  7. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  8. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR


    1. A012HZX

      Remove the 3 nuts and No. 1 front floor heat insulator.

  9. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A012N0L

      Remove the clip, and disconnect the transmission control select cable from the floor shift lever assembly.

    2. A012F90

      Disconnect the transmission control shift cable from the floor shift lever assembly.

    3. A012G0U

      Release the 2 claws, and separate the transmission control cable assembly from the floor shift lever assembly.

    4. A012KNBN02

      Remove the 2 clips (A) and disconnect the 2 transmission control cable assemblies from the manual transaxle assembly.

    5. Remove the 2 clips (B) and disconnect the 2 transmission control cable assemblies from the control cable bracket assembly.

    6. A012F46

      Remove the bolt and disconnect the transmission control cable assembly from the rear engine mounting bracket.

    7. A012G4E

      Remove the 2 nuts and transmission control cable assembly from the vehicle exterior.