МАСЛЯНЫЙ НАСОС ПРОВЕРКА

PROCEDURE

1. INSPECT OIL PUMP

   
   

   1. 

      *a

      Mark

      Install the drive and driven rotors to the timing chain cover sub-assembly with the marks of the rotors facing the cylinder block sub-assembly side. Check that the rotors revolve smoothly.

   2. 

      Check the tip clearance.

      
      

      1. Using a feeler gauge, measure the clearance between the tips of the oil pump drive rotor and oil pump driven rotor.

         Standard Tip Clearance
         0.180 to 0.300 mm (0.00709 to 0.0118 in.)

         Maximum Tip Clearance
         0.300 mm (0.0118 in.)

         If the tip clearance is more than the maximum, replace the timing chain cover sub-assembly.

   3. 

      Check the body clearance.

      
      

      1. Using a feeler gauge, measure the clearance between the oil pump driven rotor and timing chain cover sub-assembly.

         Standard Body Clearance
         0.175 to 0.250 mm (0.00689 to 0.00984 in.)

         Maximum Body Clearance
         0.250 mm (0.00984 in.)

         If the body clearance is more than the maximum, replace the timing chain cover sub-assembly.

   4. 

      Check the side clearance.

      
      

      1. Using a feeler gauge and steel square, measure the clearance between the oil pump rotors and steel square.

         Standard Side Clearance
         0.030 to 0.090 mm (0.00118 to 0.00354 in.)

         Maximum Side Clearance
         0.090 mm (0.00354 in.)

         If the side clearance is more than the maximum, replace the timing chain cover sub-assembly.