ТЕРМОСТАТ УСТАНОВКА

PROCEDURE


  1. INSTALL THERMOSTAT

    A01TCL2

    1. Align the jiggle valve with the top of the water inlet to install the thermostat.

  2. INSTALL WATER INLET


    1. Install a new gasket to the water inlet.

    2. Temporarily install the water inlet together with the thermostat with the 4 bolts by hand.

    3. Using several steps, uniformly tighten the 4 bolts.

      Tech Tips

      Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.

  3. CONNECT NO. 2 RADIATOR HOSE

    Note


    • Check that the retainer is closed when the quick connector is inserted.

    • If replacing the No. 2 radiator hose, apply new engine coolant to the O-ring.

    • Push on the quick connector until it makes a click sound which indicates that the connection is complete. After connecting the quick connector, check that the quick connector cannot be disconnected by pulling the quick connector.

    • Do not use a quick connector that has been dropped.


    1. Push in the retainer and connect the No. 2 radiator hose to the water inlet.

  4. INSTALL COMPRESSOR WITH PULLEY ASSEMBLY (w/ Air Conditioning System)

    Click here

  5. ADD ENGINE COOLANT

    Click here

  6. INSPECT FOR COOLANT LEAK

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER

    Click here