НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ УСТАНОВКА

PROCEDURE

1. Click here

   INSTALL ENGINE WATER PUMP ASSEMBLY

   
   

   1. Install a new water pump gasket to the engine water pump assembly.

      Tip:

      Be sure to clean the contact surfaces.

   2. Apply adhesive 1324 to the threads of the bolt (C).

      Bolt Length
      Item Length Bolt (A) and (D) 20 mm (0.787 in.) Bolt (B) and (C) 35 mm (1.38 in.)

   3. 

      Temporarily install the engine water pump assembly to the timing chain cover assembly with the 6 bolts.

      Note:

      Tighten the bolts within 3 minutes of applying adhesive.

   4. 

      *a	12 mm Union Nut Wrench
      *b	Torque Wrench Fulcrum Length

      Using a 12 mm union nut wrench, tighten the bolt (A).

      Specified tightening torque
      21 N*m	214 kgf*cm	15 ft.*lbf

      Tip:
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 12 mm union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 19 N*m (194 kgf*cm, 14 ft.*lbf)

   5. Tighten the bolt (B), bolt (C) and bolt (D).

      21 N*m

      214 kgf*cm

      15 ft.*lbf

2. Click here

   INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

   Click here

3. Click here

   INSTALL GENERATOR ASSEMBLY

   Click here

4. Click here

   ADD ENGINE COOLANT

   Click here

5. Click here

   INSPECT FOR COOLANT LEAK

   Click here