НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ УСТАНОВКА

PROCEDURE


  1. INSTALL ENGINE WATER PUMP ASSEMBLY


    1. Remove the adhesive from the threads of the bolt and bolt hole of the timing chain cover.

    2. A012ICU

      Install a new gasket to the timing chain cover sub-assembly so that protrusions indicated by the arrows in the illustration are aligned.

    3. A012KWWC02
      *a Adhesive

      Apply adhesive to 2 or 3 threads of the bolt (A) shown in the illustration.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    4. Temporarily install the engine water pump assembly with the 7 bolts.

      Standard Bolt Length
      Item Specified Condition
      Bolt A and C 45 mm (1.77 in.)
      Bolt B 30 mm (1.18 in.)
    5. A012M24

      Using a 24 mm deep socket wrench, tighten the 2 bolts.

      Torque:
      22.5 N*m  { 229 kgf*cm, 17 ft.*lbf }
    6. A012JP4

      Using a 24 mm deep socket wrench, tighten the 5 bolts.

      Torque:
      22.5 N*m  { 229 kgf*cm, 17 ft.*lbf }

    7. Connect the 4 injector driver connectors and install the 2 clamps.

  2. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

    Click here

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSTALL NO. 1 ENGINE COVER

    Click here

  5. ADD ENGINE COOLANT

    Click here

  6. INSPECT FOR COOLANT LEAK

    Click here