ДАТЧИК ТЕМПЕРАТУРЫ ГАЗОВ РОГ СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  5. REMOVE BATTERY INSULATOR

  6. REMOVE BATTERY

  7. REMOVE EGR GAS TEMPERATURE SENSOR


    1. B0044DHC01
      *a White-colored Lock
      *b Slide
      *c Push

      Slide the white-colored lock of the EGR gas temperature sensor connector as shown in the illustration to release it and disconnect the EGR gas temperature sensor connector.

    2. B0043KS

      Slide the clamp and disconnect the hose.

    3. B0043BW

      Using a 14 mm union nut wrench, remove the EGR gas temperature sensor.

      Note

      If the EGR gas temperature sensor is dropped, replace it with a new one.