ДАТЧИК ТЕМПЕРАТУРЫ ГАЗОВ РОГ УСТАНОВКА

PROCEDURE


  1. INSTALL EGR GAS TEMPERATURE SENSOR


    1. B0041V5C01
      *a Torque Wrench Fulcrum Length

      Using a 14 mm union nut wrench, install the EGR gas temperature sensor.

      Torque:
      Specified tightening torque
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      If the EGR gas temperature sensor is dropped, replace it with a new one.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 14 mm union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 28 N*m (286 kgf*cm, 21 ft.*lbf)

    2. Connect the hose and slide the clamp to secure the hose.

    3. Connect the EGR gas temperature sensor connector and slide the white-colored lock to engage it securely.

  2. INSTALL BATTERY

  3. INSTALL BATTERY INSULATOR

  4. INSTALL BATTERY CLAMP SUB-ASSEMBLY

    Click here

  5. CONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  6. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here