ДИФФЕРЕНЦИАЛЬНЫЙ ДАТЧИК ДАВЛЕНИЯ (для моделей с контроллером свечей накаливания) ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. INSPECT DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

    Tech Tips

    The type of ignition switch used on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the"Expressions of Ignition Switch" precaution.

    Click here


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / DPF Differential Pressure.


      Powertrain > Engine and ECT > Data List
      Tester Display
      DPF Differential Pressure

    5. Slide the clip and disconnect the No. 1 vacuum transmitting hose assembly from the differential pressure sensor assembly.

    6. A01LZCME02

      Using SST, apply pressure to the differential pressure sensor assembly.

      SST
      09992-00242

    7. Check the pressure value of the differential pressure sensor assembly.

      Standard Pressure
      Approximately the same pressure as the applied pressure is indicated.

      Note

      Perform the inspection within the range of 0 to 98 kPa (0 to 1 kg/cm2, 0 to 14.2 psi).

      If the result is not as specified, check the differential pressure sensor assembly circuit.

      Click here

    8. Connect the No. 1 vacuum transmitting hose assembly to the differential pressure sensor assembly and slide the clip to secure it.