СВЕЧА НАКАЛИВАНИЯ (для моделей с контроллером свечей накаливания) УСТАНОВКА

PROCEDURE

1. INSTALL GLOW PLUG ASSEMBLY

   
   

   1. Clean the glow plug assembly installation holes in the cylinder head sub-assembly.

   2. Using a 10 mm deep socket wrench, install the 4 glow plug assemblies.

      Torque:

      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

2. INSTALL NO. 1 GLOW PLUG CONNECTOR

   
   

   1. Install the No. 1 glow plug connector to the glow plug assemblies with the 4 nuts.

      Torque:

      2.2 N*m  { 22 kgf*cm, 19 in.*lbf }

   2. Install the 4 glow plug screw grommets to the glow plug assemblies.

      Note

      Push the glow plug screw grommet into the threaded portion of the glow plug assembly by hand, and then turn it clockwise.

   3. Engage the clamp.

   4. Connect the No. 1 glow plug connector connector.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

   Click here