ДАТЧИК ТЕМПЕРАТУРЫ ТОПЛИВА УСТАНОВКА

PROCEDURE


  1. INSTALL FUEL TEMPERATURE SENSOR

    Note

    If the fuel temperature sensor is dropped, replace it with a new one.


    1. Apply a light coat of engine oil to a new O-ring.

    2. Install the O-ring to the fuel temperature sensor.

    3. Temporarily install the fuel temperature sensor to the supply pump assembly.

    4. A01D5XUC01
      *a Length of SST 135 mm (5.31 in.)
      *b Length of Torque Wrench 180 mm (7.09 in.)

      Using SST, tighten the fuel temperature sensor.

      SST
      09922-10010
      Torque:
      without SST [Torque (N*m (kgf*cm, ft.*lbf))]
      22 N*m  { 224 kgf*cm, 16 ft.*lbf }
      with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 135 mm (5.31 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

  2. INSTALL SUPPLY PUMP ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. PERFORM INITIALIZATION

    Click here

  5. BLEED AIR FROM FUEL SYSTEM

    Click here

  6. INSPECT FOR FUEL LEAK

    Click here