БЛОК ЦИЛИНДРОВ (для моделей с контроллером свечей накаливания) ЗАМЕНА

PROCEDURE


  1. REPLACE STRAIGHT PIN


    1. Remove the 9 straight pins shown in the illustration from the cylinder block sub-assembly.

      A01LZLRC01
      *a Front Side *b Upper Side
      *c Rear Side *d Lower Side
      *e LH Side - -

    2. Using a plastic hammer, tap in 9 new straight pins.

      A01M113C01
      *a Front Side *b Upper Side
      *c Rear Side *d Lower Side
      *e LH Side *f 18.0 mm (0.709 in.)
      *g 8.5 to 9.5 mm (0.335 to 0.374 in.) *h 22.0 mm (0.866 in.)
      *i 11.5 to 12.5 mm (0.453 to 0.492 in.) *j 12.0 mm (0.472 in.)
      *k 5.5 to 6.5 mm (0.217 to 0.256 in.) - -

  2. REPLACE STUD BOLT


    1. Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the cylinder block sub-assembly.

    2. A01LVUT

      Using an E6 "TORX" socket wrench, install the 2 stud bolts to the cylinder block sub-assembly.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }