ECM СНЯТИЕ

PROCEDURE


  1. PERFORM REGISTRATION

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 1 ENGINE COVER

    Click here

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. SEPARATE NO. 1 AIR CLEANER INLET


    1. B00447G

      Remove the bolt and separate the No. 1 air cleaner inlet.

      Note

      Move the No. 1 air cleaner inlet to ensure enough space for the removal and installation of the ECM installation bolt.

  9. REMOVE ECM


    1. B00426MC01
      B0042CO Push
      B0043VS Raise

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. B0044B3

      Remove the 2 bolts and disengage the guide to remove the ECM.

      Note

      If the ECM has been struck or dropped, replace it.

    3. B00432FC01
      *1 No. 1 ECM Bracket
      *2 No. 2 ECM Bracket

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

    4. Remove the 2 screws and No. 2 ECM bracket from the ECM.