КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ ДИЗЕЛЬНОГО ДВИГАТЕЛЯ СНЯТИЕ

PROCEDURE


  1. REMOVE RADIATOR ASSEMBLY

    Click here

  2. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A0030S9

      Disengage the 2 clamps.

    2. A00318UN01

      Using a T27 "TORX" socket wrench, remove the 2 bolts (A).

    3. Remove the bolt (B) and wire harness clamp bracket.

  3. REMOVE NO. 3 AIR HOSE


    1. A003136

      Loosen the hose clamp and remove the No. 3 air hose from the air tube assembly.

  4. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    1. A002ZPXC01
      *1 Water By-pass Hose Assembly
      *2 Radiator Hose Sub-assembly

      Disconnect the water by-pass hose assembly and radiator hose sub-assembly from the air tube assembly.

    2. A0030OU

      Detach the 2 wire harness clamps.

    3. A002ZMW

      Disconnect the intake air temperature sensor connector.

    4. A00308R

      Disconnect the No. 7 engine wire connector and disengage the clamp.

    5. A003159

      Using a T27 "TORX" socket wrench, remove the bolt and separate the air tube assembly from the cylinder block sub-assembly.

    6. A0030NL

      Using an E8 "TORX" socket wrench, remove the 3 bolts, diesel throttle body assembly with air tube assembly and gasket from the intake manifold.

      Note

      If the diesel throttle body assembly has been struck or dropped, replace it.

    7. Disengage the 2 claws and remove the air tube assembly from the diesel throttle body assembly.

    8. Remove the gasket from the air tube assembly.

    9. A00306X

      Disconnect the diesel throttle body assembly connector.