Click here

СИСТЕМА ECD, Diagnostic DTC:P064C

Click here
Click here
DTC Code DTC Name
P064C Glow Plug Control Module 1
Click here

DESCRIPTION

When it is determined that there is a malfunction in the glow plug control assembly, a malfunction signal is sent via LIN communication. This DTC is stored when the malfunction signal is received by the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P064C Glow Plug Control Module 1

Preheating control unit internal fault for 1.2 seconds.

(3 trip detection logic)

 Glow plug controller assembly Does not come on DTC stored
Click here

CAUTION / NOTICE / HINT

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    REPLACE GLOW PLUG CONTROLLER ASSEMBLY


    1. Replace the glow plug controller assembly.

      Click here

      Result
      Proceed to
      NEXT

  2. Click here

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.


      1. Powertrain > Engine and ECT > Clear DTCs


    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


      1. Powertrain > Engine and ECT > Trouble Codes


    8. Confirm that the DTC is not output again.

      Result
      Proceed to
      NEXT

    • NEXT

      END