ТОПЛИВНЫЙ НАСОС РАЗБОРКА

PROCEDURE

1. REMOVE FUEL SENDER GAUGE ASSEMBLY

   Click here

2. REMOVE FUEL PUMP

   
   

   1. 

      Disconnect the fuel pump harness connector.

   2. 

      Disengage the clamp and claw, and disconnect the fuel pump filter hose from the fuel sub-tank.

   3. 

      *a	Tube
      *b	Fuel Sub-tank

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the fuel filter and fuel pump from the fuel sub-tank.

      Note

      Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.

      Click here

   4. 

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.

   5. 

      *a	Fuel Filter
      *b	Suction Filter
      *c	Tube

      Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.

      Note

      
      

      • Do not damage the fuel filter or suction filter.

      • Do not remove the suction filter from the fuel pump.

      • Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.

        Click here

   6. 

      Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump.

   7. 

      *1	O-ring
      *2	Fuel Pump Spacer
      *a	5.0 mm (0.197 in.)

      Remove the O-ring and fuel pump spacer from the fuel pump.

      Note

      Be careful not to damage the sealing surface.

      Tech Tips

      If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.