ДАТЧИК ДЕТОНАЦИИ УСТАНОВКА

PROCEDURE

1. INSTALL KNOCK CONTROL SENSOR

   Tech Tips

   Perform "Inspection After Repair" after replacing the knock control sensor.

   Click here

   
   
   1. 

      *a	Top
      *b	Front of Engine
      *c	Mark
      *d	12.5°
      *e	5°

      Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note

      
      

      • If the knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

   2. Connect the knock control sensor connector.

   3. Install the No. 4 engine wire with the bolt.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

2. INSTALL GENERATOR ASSEMBLY

   Click here

3. PERFORM INITIALIZATION

   
   

   1. Perform "Inspection After Repair" after replacing the knock control sensor.

      Click here