ECM СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • If the ECM has been struck or dropped, replace it.

    • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.

      Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. REMOVE ECM


    1. B0042X6

      Remove the bolt and shift the No. 1 air cleaner inlet.

    2. B0042YP

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    3. Disengage the wire harness clamp.

    4. B00421T

      Remove the 2 bolts and disengage the guide to remove the ECM.

      Note

      If the ECM has been struck or dropped, replace it.

  6. REMOVE ECM BRACKET


    1. B0042BM

      Remove the 2 screws and ECM bracket from the ECM.

  7. REMOVE NO. 2 ECM BRACKET


    1. B00444C

      Remove the 2 screws and No. 2 ECM bracket from the ECM.