ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ (для моделей без контроллера свечей накаливания) УСТАНОВКА

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A01TB1HC01
      *a Length of SST 30 mm (1.18 in.)
      *b Length of Torque Wrench 300 mm (11.8 in.)

      Using SST, install the air fuel ratio sensor onto the exhaust manifold converter sub-assembly.

      SST
      09224-00010
      Torque:
      without SST [Torque (N*m(kgf*cm, ft.*lbf))]
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips


      • The "with SST" torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

  2. INSTALL WIRE HARNESS CLAMP BRACKET


    1. w/ No. 1 Engine Cover


      1. Install the wire harness clamp bracket.

      2. Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.

      3. Connect the connector to the air fuel ratio sensor.

    2. w/o No. 1 Engine Cover


      1. Install the wire harness clamp bracket.

      2. Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.

      3. Connect the connector to the air fuel ratio sensor.

      4. Install the nut.

        Torque:
        11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  3. INSTALL NO. 2 ENGINE COVER BRACKET (w/ No. 1 Engine Cover)


    1. Install the No. 2 engine cover bracket with the 2 nuts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  4. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  5. INSTALL OUTER COWL TOP PANEL

    Tech Tips


  6. PERFORM INITIALIZATION

    Click here