ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ (для моделей без контроллера свечей накаливания) СНЯТИЕ

PROCEDURE


  1. REMOVE OUTER COWL TOP PANEL

    Tech Tips


  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. REMOVE NO. 2 ENGINE COVER BRACKET (w/ No. 1 Engine Cover)


    1. A01TB07

      Remove the 2 nuts and No. 2 engine cover bracket.

  4. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01T9HE

      w/ No. 1 Engine Cover


      1. Disconnect the connector from the air fuel ratio sensor.

      2. Disengage the 5 clamps and disconnect the wire harness from the wire harness clamp bracket.

      3. Remove the wire harness clamp bracket.

    2. A01TAZS

      w/o No. 1 Engine Cover


      1. Remove the nut.

      2. Disconnect the connector from the air fuel ratio sensor.

      3. Disengage the 5 clamps and disconnect the wire harness from the wire harness clamp bracket.

      4. Remove the wire harness clamp bracket.

  5. REMOVE AIR FUEL RATIO SENSOR


    1. A01T8GWE03

      Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.

      SST
      09224-00010

      Note

      If a component has been dropped or subjected to a strong impact, replace it.