ECM (для моделей без контроллера свечей накаливания) СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. SEPARATE NO. 1 AIR CLEANER INLET


    1. A01T97R

      Remove the bolt and separate the No. 1 air cleaner inlet.

  7. REMOVE ECM


    1. A01TBHH

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 connectors from the ECM.

      Note

      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    2. A01T9OQ

      Remove the 2 bolts, clamp and ECM.

  8. REMOVE NO. 1 ECM BRACKET

    A01TDQG

    1. Remove the 2 screws and No. 1 ECM bracket.

  9. REMOVE NO. 2 ECM BRACKET

    A01TC3Q

    1. Remove the 2 screws and No. 2 ECM bracket.