POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) PRECAUTION

CAUTION:

• The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

  Click here

• The power window control system prohibits the auto up and down function when the jam protection function malfunctions.

• If the door window regulator assembly has been replaced with a new one, initialize the power window control system.

• If a door window regulator assembly has been removed and installed, or if the door window regulator assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

• After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:




1. Close the power window by fully pulling up the power window regulator master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly and holding it at the auto up position.

2. Open the power window by fully pushing down the power window regulator master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly.

• The jam protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:




1. A power window is being opened or closed while the vehicle is driven on a rough road.

2. A power window is being opened or closed while the door is being opened or closed.

3. The voltage changes abruptly.