CONDENSER INSTALLATION

PROCEDURE


  1. INSTALL CONDENSER WITH RECEIVER ASSEMBLY


    1. A01KR0C

      Engage the 2 guides to install the condenser with receiver assembly as shown in the illustration.

      Note

      Do not damage the condenser or radiator when installing the condenser with receiver assembly.

      Tech Tips

      If a new condenser with receiver assembly is installed, add compressor oil to the condenser as follows.

      Capacity
      Add 40 cc (1.35 fl. oz.)
      Compressor Oil
      ND-OIL 11 or equivalent

    2. Install the radiator assembly with the 4 bolts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

  2. CONNECT AIR CONDITIONER TUBE ASSEMBLY


    1. Remove the vinyl tape from the air conditioner tube assembly and the connecting part of the condenser with receiver assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

      Compressor Oil
      ND-OIL 11 or equivalent

    3. Install the O-ring to the air conditioner tube assembly.

    4. Install the air conditioner tube assembly to the condenser with receiver assembly with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  3. CONNECT DISCHARGE HOSE SUB-ASSEMBLY


    1. Remove the vinyl tape from the discharge hose sub-assembly and the connecting part of the condenser with receiver assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

      Compressor Oil
      ND-OIL 11 or equivalent

    3. Install the O-ring to the discharge hose sub-assembly.

    4. Install the discharge hose sub-assembly to the condenser with receiver assembly with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. INSTALL NO. 2 FAN SHROUD


    1. Engage the 2 guides and 2 claws.

    2. Install the No. 2 fan shroud with the 2 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    3. Engage the 4 clamps to connect the No. 3 water by-pass hose to the No. 2 fan shroud.

  5. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY

    Click here

  6. INSTALL RADIATOR SUPPORT LH

    Click here

  7. INSTALL RADIATOR SUPPORT RH

    Click here

  8. INSTALL NO. 1 INVERTER BRACKET

    Click here

  9. INSTALL HEADLIGHT ASSEMBLY LH

    Click here

  10. INSTALL HEADLIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  11. ADJUST HOOD SUB-ASSEMBLY

    Click here

  12. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

    Click here

  13. WARM UP COMPRESSOR

    Click here

  14. INSPECT FOR REFRIGERANT LEAK

    Click here