CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A00YPMVC01
      *1 Airbag Connector
      *2 Airbag Connector Lock
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock and disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Using a clip remover, remove the 6 pins.

    5. Using 2 screwdrivers, disengage the 2 claws and remove each clip from the body panel as shown in the illustration.

      A00YP6GC01
      *1 Pin *2 Claw

    6. While holding the curtain shield airbag assembly, remove the 2 bolts and disengage the 4 clips.

      A00YP8X

      Note

      When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

    7. Disengage the 2 hooks to remove the curtain shield airbag assembly.

      A00YP3B

    8. Remove the 2 spacers from the curtain shield airbag assembly.