KNEE AIRBAG ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      *1	Airbag Connector
      *2	Airbag Connector Lock

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the airbag connector lock to install the airbag connector.

   5. Engage the 6 claws and 2 guides to temporarily install the lower No. 1 instrument panel airbag assembly.

   6. Install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

   Click here

3. INSTALL NO. 1 SWITCH HOLE BASE (for LHD)

   Click here

4. INSTALL NO. 1 SWITCH HOLE BASE (for RHD)

   Click here

5. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

   Click here

6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

   Click here

7. INSTALL NO. 1 METER HOOD CLUSTER

   Click here

8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

9. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

   Click here

10. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

11. INSTALL BATTERY BOX COVER

    Click here

12. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

13. INSPECT SRS WARNING LIGHT

    Click here