METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Warm up the engine.

    2. Turn the power switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the power switch on (IG).

    5. Turn the GTS on.

    6. Enter the following menus:


      1. for Combination Meter: Body Electrical / Combination Meter / Data List.

      2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

      4. for Main Body: Body Electrical / Main Body / Data List.

    7. Check the values by referring to the table below.


      Body Electrical > Combination Meter > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Tail Relay SW Tail relay OFF or ON

      OFF: Tail relay off

      ON: Tail relay on

      		 -
      ODO/TRIP Change SW ODO/TRIP switch OFF or ON

      OFF: Switch released

      ON: Switch pushed

      		 -
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch OFF or ON

      OFF: Front passenger seat belt fastened (warning light off)

      ON: Front passenger seat belt unfastened (warning light on)

      		 -
      Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
      Engine Rpm Engine speed Min.: 0 rpm, Max.: 12750 rpm 600 to 700 rpm (Idling) -
      Coolant Temperature Engine coolant temperature 0 to 127.5°C (0 to 261.5°F) 75 to 100 °C (167 to 212°F) (After warming up engine) -
      Multi Display Select Switch DISP switch OFF or ON

      OFF: DISP switch not pressed

      ON: DISP switch pressed

      		 -
      +B Voltage Value Auxiliary battery voltage Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Fuel Input Fuel input Min.: 0 L, Max.: 127.5 L

      Fuel receiver gauge indicates F: 39.6 L

      Fuel receiver gauge indicates 3/4: 31.5 L

      Fuel receiver gauge indicates 1/2: 22.5 L

      Fuel receiver gauge indicates 1/4: 13.1 L

      Fuel receiver gauge indicates E: 4.5 L

      		 -
      Ambient Temperature Outside temperature Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
      HV System Indicator Hybrid system indicator value Min.: -512%, Max.: 511% -512 to 511% -
      2nd-Row Seatbelt Buckle (R) Rear seat belt buckle switch RH OFF or ON

      ON: Rear seat belt buckle switch RH unfastened

      OFF: Rear seat belt buckle switch RH fastened

      		 -
      2nd-Row Seatbelt Buckle (L) Rear seat belt buckle switch LH OFF or ON

      ON: Rear seat belt buckle switch LH unfastened

      OFF: Rear seat belt buckle switch LH fastened

      		 -
      2nd-Row Seatbelt Buckle (C) Rear seat belt buckle switch center OFF or ON

      ON: Rear seat belt buckle switch center unfastened

      OFF: Rear seat belt buckle switch center fastened

      		 -
      Oil Pressure Switch Oil pressure switch OFF or ON

      OFF: Engine started

      ON: Engine not started

      		 -
      Turn Signal Switch (Right) RH turn signal switch OFF or ON

      OFF: RH turn signal switch off

      ON: RH turn signal switch on

      		 -
      Turn Signal Switch (Left) LH turn signal switch OFF or ON

      OFF: LH turn signal switch off

      ON: LH turn signal switch on

      		 -
      Hazard Flasher Switch Hazard warning switch OFF or ON

      OFF: Hazard warning switch off

      ON: Hazard warning switch on

      		 -
      Key Remind Sound Cycle of the key reminder warning buzzer Normal, Slow, Fast Normal, Slow, Fast Displays customize setting of key remind sound
      Driver Side Seatbelt Warning Buzzer Condition of the driver seat belt warning buzzer OFF or ON

      OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened

      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened

      		 Displays customize setting of driver side seat belt warning buzzer
      P-Seatbelt Warning Buzzer Condition of the front passenger seat belt warning buzzer OFF or ON

      OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened

      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened

      		 Displays customize setting of front passenger side seat belt warning buzzer
      Rear Seatbelt Warning Buzzer Condition of the rear seat belt warning buzzer OFF or ON

      OFF: Rear seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when rear seat belt unfastened

      ON: Rear seat belt warning displayed buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when rear seat belt unfastened

      		 Displays customize setting of rear seat belt warning buzzer
      Reverse Buzzer Condition of the reverse buzzer Continual, Signal

      Continual: Reverse (R) has been selected, buzzer sounds continuously

      Signal: Reverse (R) has been selected, a signal buzzer sounds

      		 Displays customize setting of reverse buzzer
      Number of Trouble Code The number of the DTC currently stored Min.: 0, Max.: 255 0 -

      Chassis > ABS/VSC/TRC > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations

      Powertrain > Engine and ECT > Data List
      Tester Display Measurement Item Range Normal Condition Reference Value Diagnostic Note
      Coolant Temp Coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up engine -

      • Stored as Freeze Frame Data: Yes

      • This is the engine coolant temperature.

      Tech Tips


      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient temperature are approximately equal.

      • If the value is -40°C (-40°F), or 140°C (284°F), the sensor circuit is open or shorted.

      • Check if the engine overheats when the value indicates 140°C (284°F).

      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Illumination Rate Info Illumination rate information 0.00 ms. to 2162.65 ms. Value output according to ambient light level -

  2. ACTIVE TEST

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Check the operation by referring to the table below.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Speed Meter Operation Speedometer

      • OFF, 0, 40, 80, 120, 160, 200, 240 km/h*4


      • OFF, 0, 40, 80, 120, 160 mph*5

      		 -
      Fuel Meter Operation Fuel receiver gauge OFF, Empty, 1/2, Full -
      A/T Indicator Operation 1 Shift indicator OFF, L, 2, 3(M), 4(M), D, N, R, P -
      A/T Indicator Operation 2 Shift indicator OFF, 5, 6, 7, Es, M, S, B -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Front Passenger Side Seat Belt Driver or front passenger seat belt warning light OFF or ON -
      Driver Side Seat Belt Driver or front passenger seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Tail Tail indicator light OFF or ON -
      Indicat. AFS AFS OFF warning light OFF or ON *1
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      Indicat. Lamp ECB Electrically controlled brake warning light OFF or ON -
      Indicat. Lamp ECT PWR Power mode indicator light OFF or ON -
      Indicat. Lamp Cruise Cruise main indicator light OFF or ON *2
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. Ready (HV) Ready indicator light OFF or ON -
      Indicat. EV Mode EV MODE indicator light OFF or ON -
      Indicat. SET Cruise SET indicator light OFF or ON *2
      Indicat. ECO MODE ECO MODE indicator light OFF or ON -
      Rear Seat Belt Rear seat belt indicator light OFF or ON -
      Automatic High Beam Indicator Automatic high beam indicator light OFF or ON *3
      EV Mode Indicator EV indicator light OFF or ON -
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
      HV System Indicator Hybrid system indicator OFF, MIN, -50%, 0%, 100%, 200%, 300%, 400%, MAX -
      Meter Display 1 Multi-information display OFF, All -

      • *1: w/ AFS (Adaptive Front-lighting System)

      • *2: w/ Cruise control system

      • *3: w/ Automatic high beam system

      • *4: for Speedometer with Metric units

      • *5: for Speedometer with Imperial units