REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

   Click here

2. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)

   Click here

3. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

   Click here

4. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

   Click here

5. INSTALL REAR DOOR LOCK ASSEMBLY

   Note

   
   

   • When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

   • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

   • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock assembly.

   
   

   1. Apply MP grease to the sliding parts of the rear door lock assembly.

   2. When reusing the rear door lock assembly:

      
      

      1. 

         Install a new door lock wiring harness seal to the rear door lock assembly.

   3. 

      *a	Release Plate

      Connect the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.

      Tech Tips

      Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

   4. Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

      Torque:

      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

8. INSTALL REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

   Click here

9. CONNECT REAR DOOR GLASS RUN

   Click here

10. CONNECT REAR DOOR WEATHERSTRIP

    Click here

11. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

14. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

15. INSTALL REAR ARMREST ASSEMBLY (w/o Power Window)

    Click here

16. INSTALL REAR ARMREST ASSEMBLY (w/ Power Window)

    Click here

17. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL (w/ Power Window)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

18. INSTALL BATTERY BOX COVER (w/ Power Window)

    for Hatchback:

    Click here

    for Wagon:

    Click here

19. INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Power Window)

    Click here

20. INSPECT POWER WINDOW OPERATION (w/ Power Window)

    Click here