ULTRASONIC SENSOR(for Front Side) INSTALLATION

PROCEDURE


  1. INSTALL ULTRASONIC SENSOR BEZEL

    Tech Tips

    Use the same procedure for all ultrasonic sensor bezels.


    1. A00YB5UC01
      *a Protrusion
      *b Cutout

      Install the ultrasonic sensor bezel to the front bumper assembly.

      Note


      • Do not damage the front bumper assembly with the protrusion when installing the ultrasonic sensor bezel.

      • Securely install the ultrasonic sensor bezel so that there are no gaps between the ultrasonic sensor bezel and surface of the front bumper assembly.

      Tech Tips

      When installing the ultrasonic sensor bezel, align the cutout and protrusion as shown in the illustration.

  2. INSTALL ULTRASONIC SENSOR BEZEL (for Simple Intelligent Parking Assist System)


    1. A00Y8HQC01
      *a Protrusion
      *b Cutout

      Install the ultrasonic sensor bezel to the front bumper assembly.

      Note


      • Do not damage the front bumper assembly with the protrusion when installing the ultrasonic sensor bezel.

      • Securely install the ultrasonic sensor bezel so that there are no gaps between the ultrasonic sensor bezel and surface of the front bumper assembly.

      Tech Tips


      • When installing the ultrasonic sensor bezel, align the cutout and protrusion as shown in the illustration.


      • This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  3. INSTALL ULTRASONIC SENSOR CLIP

    Tech Tips

    Use the same procedure for all ultrasonic sensor clips.


    1. Engage the 2 claws to install the ultrasonic sensor clip.

  4. INSTALL ULTRASONIC SENSOR CLIP (for Simple Intelligent Parking Assist System)

    Tech Tips

    Use the same procedure for all ultrasonic sensor clips.


    1. Engage the 2 claws to install the ultrasonic sensor clip.

  5. INSTALL NO. 2 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for all No. 2 ultrasonic sensors.


    1. Engage the 2 claws to install the No. 2 ultrasonic sensor.

    2. Connect the connector.

    3. Engage the clamp.

  6. INSTALL NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensors.


    1. Engage the 2 claws to install the No. 1 ultrasonic sensor.

    2. Connect the connector.

    3. A00YAZ5

      Slide the connector lock in the direction indicated by the arrow in the illustration.

      Tech Tips

      This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  7. INSTALL FRONT BUMPER ASSEMBLY

    Click here