ГЕНЕРАТОР СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE RADIATOR ASSEMBLY

    Click here

  4. REMOVE NO. 1 ENGINE COVER

    Click here

  5. REMOVE V-RIBBED BELT

    Click here

  6. REMOVE GENERATOR ASSEMBLY


    1. B004269

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the generator assembly connector.

    4. B0042EBN01

      Using an E12 "TORX" socket wrench, fully loosen the bolt (A).

    5. Using an E12 "TORX" socket wrench, remove the bolt (B).

    6. B0042E4C01
      B0042CO Remove in this Direction

      Remove the generator assembly together with the bolt (A) from the engine assembly as shown in the illustration.

      Tech Tips

      There is not enough clearance to completely remove the bolt (A) from the generator assembly. Remove the generator assembly together with the bolt (A).

    7. Remove the bolt (A) from the generator assembly.