ROOF DRIP SIDE FINISH MOULDING(for Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING

    Tech Tips

    When removing the center roof drip side finish moulding, heat the vehicle body and center roof drip side finish moulding using a heat light.

    Heating Temperature
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Center Roof Drip Side Finish Moulding 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or center roof drip side finish moulding excessively.


    1. Using a heat light, heat the center roof drip side finish moulding.

    2. A012H16C01
      A012F6O Protective Tape

      Put protective tape around the center roof drip side finish moulding.

    3. Using a moulding remover, disengage the 2 No. 1 roof drip side finish moulding clips and remove the center roof drip side finish moulding.

      Note


      • Do not remove the No. 1 roof drip side finish moulding clips.

      • If any No. 1 roof drip side finish moulding clip is damaged or falls out, replace it with a new one.