ДАТЧИК ТОКА АККУМУЛЯТОРНОЙ БАТАРЕИ СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY STATE SENSOR ASSEMBLY


    1. B0042JT

      Remove the nut and disconnect the engine wire from the battery state sensor assembly.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    2. B0042AN

      Loosen the nut and remove the battery state sensor assembly from the battery.

    3. B00444D

      Disengage the clamp and disconnect the battery state sensor assembly connector.

    4. B0041R0

      Disengage the 2 claws to remove the battery state sensor assembly from the battery state sensor holder.