ГЕНЕРАТОР СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE V-RIBBED BELT

    Click here

  4. REMOVE GENERATOR ASSEMBLY


    1. B0043E5

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the generator assembly connector.

    4. Disengage the wire harness clamp.

    5. Remove the bolt and 2 nuts.

    6. B0043HU

      Using an E8 "TORX" socket wrench, remove the stud bolt.

    7. Remove the generator assembly.

    8. B004501

      Remove the bolt and wire harness clamp bracket from the generator assembly.