INITIALIZATION
Note
Perform Registration (Switch Battery Type) when replacing the ECM (w/ Stop and Start System).
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Stop and Start System | |
| Simple Intelligent Parking Assist System | |
| Power door lock control system (for Hatchback, Wagon) |
IGNITION SWITCH EXPRESSIONS
Tech Tips
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
CHARGING SYSTEM PRECAUTION
Note
Check that the battery cables are connected to the correct terminals.
Disconnect the battery cables when the battery is given a quick charge.
Do not perform tests with a high voltage insulation resistance tester.
Never disconnect the battery cables while the engine is running.
Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the engine room relay block and junction block assembly.