NOISE FILTER(for Hatchback) REMOVAL

PROCEDURE


  1. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

  2. REMOVE REAR FLOOR MAT ASSEMBLY

    Click here

  3. REMOVE REAR DECK FLOOR BOX (w/ Deck Floor Box)

    Click here

  4. REMOVE DECK FLOOR BOX LH (w/ Deck Floor Box)

    Click here

  5. REMOVE DECK FLOOR BOX RH (w/ Deck Floor Box)

    Click here

  6. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

    Click here

  7. REMOVE REAR DECK TRIM COVER

    Click here

  8. REMOVE REAR SEAT ASSEMBLY

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  10. REMOVE REAR UNDER SIDE COVER LH

    Click here

  11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  12. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

    Click here

  13. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  14. REMOVE NO. 2 DECK SIDE TRIM HOOK

    Click here

  15. REMOVE LOWER DECK TRIM SIDE BOARD LH (w/ Deck Board)

    Click here

  16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  17. REMOVE RADIO SETTING CONDENSER

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A01KRDX

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A01KRKZ

      Disengage the claw and pull out the cover as shown in the illustration.

    4. A01KTKC

      Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.

    5. A01KTPM

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    6. Remove the terminal cover from the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.