AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

• The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.

  The sound signal that has been sent is amplified by the stereo component amplifier assembly*1, and then is sent to the speakers.

  If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly*1, radio and display receiver assembly or speakers.

  *1: for 9 Speakers

WIRING DIAGRAM

*1	(Shielded)
*2	No. 1 Stereo Jack Adapter Assembly
*3	Radio and Display Receiver Assembly

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

   
   

   1. Disconnect the E60 radio and display receiver assembly connector.

   2. Disconnect the u1 No. 1 stereo jack adapter assembly connector.

   3. 

      *a	Front view of wire harness connector (to Radio and Display Receiver Assembly)
      *b	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition E60-25 (ADPG) - u1-9 (AUXO) Always Below 1 Ω E60-11 (AGND) - u1-10 (AGND) Always Below 1 Ω E60-26 (VAR+) - u1-6 (ARO) Always Below 1 Ω E60-28 (VAL+) - u1-7 (ALO) Always Below 1 Ω E60-27 (VA-) - u1-8 (ASGN) Always Below 1 Ω E60-25 (ADPG) - Body ground Always 10 kΩ or higher E60-11 (AGND) - Body ground Always 10 kΩ or higher E60-26 (VAR+) - Body ground Always 10 kΩ or higher E60-28 (VAL+) - Body ground Always 10 kΩ or higher E60-27 (VA-) - Body ground Always 10 kΩ or higher

      Result
      Proceed to OK NG

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR