STEERING COLUMN ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE HORN BUTTON ASSEMBLY

    Click here

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE STEERING COLUMN COVER


    1. A01KSZP

      Remove the 2 screws.

    2. A01KR5Z

      Disengage the 5 claws and remove the steering column cover (lower).

    3. A01KSLP

      Disengage the 2 claws and remove the steering column cover (upper).

  6. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch On (IG).

    • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch On (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Disconnect each connector from the turn signal switch assembly with spiral cable sub-assembly.

    2. A01KSMHC01
      *a Clamp
      *b Claw

      Using pliers, expand the clamp.

    3. While holding the clamp expanded, raise the claw using a screwdriver to disengage it, and then remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.

  7. REMOVE COLUMN HOLE COVER SILENCER SHEET


    1. Turn back the floor carpet.

    2. A01KT15

      Remove the 2 clips and column hole cover silencer sheet.

  8. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY


    1. A01KRKRC01
      *a Matchmark

      Put matchmarks on the No. 2 steering intermediate shaft assembly and steering intermediate shaft assembly.

    2. Remove the bolt.

    3. Separate the No. 2 steering intermediate shaft assembly from the steering intermediate shaft assembly.

  9. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY


    1. A01KTHYC01
      *a Matchmark

      Remove the bolt and slide the No. 2 steering intermediate shaft assembly.

      Note

      Do not separate the No. 2 steering intermediate shaft assembly from the steering column assembly.

    2. Put matchmarks on the No. 2 steering intermediate shaft assembly and the steering column assembly.

    3. Remove the No. 2 steering intermediate shaft assembly from the steering column assembly.

  10. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


  11. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

    Click here

  12. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  13. REMOVE STEERING COLUMN ASSEMBLY


    1. A01KT8P

      Disconnect the 2 connectors.

    2. Disengage the 2 wire harness clamps.

    3. Disconnect each connector and disengage each wire harness clamp from the steering column assembly.

    4. A01KTHM

      Remove the bolt, 2 nuts and steering column assembly.