STEERING COLUMN ASSEMBLY DISASSEMBLY

PROCEDURE


  1. REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY

    Note


    • Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.

    • If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.

    • Do not pull the wire harness of the power steering ECU with motor assembly.

    • Do not allow any moisture to come into contact with the power steering ECU with motor assembly.

    • Do not loosen any bolts not mentioned in the procedure.

    • Do not allow any foreign matter to contaminate the power steering ECU with motor assembly.


    1. A00YNSY

      Disconnect the connector.

    2. Disengage the wire harness clamp.

    3. A00YOQV

      Using a T40 "TORX" socket wrench, Remove the 2 bolts, bracket and power steering ECU with motor assembly from the electric power steering column sub-assembly.

      Tech Tips

      If the bolts have been replaced in the past, the power steering ECU with motor assembly should be installed to the electric power steering column sub-assembly with hexagon bolts.

    4. A00YOML

      Remove the electric power steering motor shaft spacer from the electric power steering column sub-assembly.

    5. A00YNF7

      Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.