POWER STEERING SYSTEM, Diagnostic DTC:C1515

DTC Code DTC Name
C1515 Torque Sensor Zero Point Adjustment Undone

DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not been performed.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1515 Torque Sensor Zero Point Adjustment Undone This DTC is stored when torque sensor zero point calibration has not been performed. - EPS Warning Light: Comes on Zero point calibration occurs There is no malfunction if this DTC is not output again after performing zero point calibration.

CAUTION / NOTICE / HINT

Note


  • If the electric power steering column sub-assembly has been replaced with a new one, perform torque sensor zero point calibration.

    Click here

  • If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration.

    Click here

PROCEDURE


  1. CHECK FOR DTC


    1. Calibrate the torque sensor zero point (step 1).

      Click here


      Chassis > EMPS > Utility
      Tester Display
      Torque Sensor Adjustment

    2. Check for DTCs (step 2).

      Click here


      Chassis > EMPS > Trouble Codes

      Tech Tips

      If DTCs are output, perform steps 1 and 2 two more times.

      Result
      Result Proceed to
      DTCs are still output after performing steering zero point calibration 3 times. A
      Normal system code is output. B

    B

    END

    A

  2. REPLACE POWER STEERING ECU ASSEMBLY


    1. Replace the power steering ECU assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTC


    1. Calibrate the torque sensor zero point (step 1).

      Click here


      Chassis > EMPS > Utility
      Tester Display
      Torque Sensor Adjustment

    2. Check for DTCs (step 2).

      Click here


      Chassis > EMPS > Trouble Codes

      Tech Tips

      If DTCs are output, perform steps 1 and 2 two more times.

      Result
      Result Proceed to
      DTCs are still output after performing steering zero point calibration 3 times. A
      Normal system code is output. B

    A

    REPLACE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY Click here

    B

    END