STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch On (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch On (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. A01KTM3C01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    2. Put matchmarks on the steering wheel assembly and steering main shaft.

    3. Disconnect each connector from the spiral cable sub-assembly.

    4. A01KRPEC01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  5. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  6. REMOVE CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Remove the cruise control switch wire.

  7. REMOVE LOWER STEERING WHEEL BOSS COVER


    1. A01KR2U

      Disengage the 4 pins and 2 claws to remove the lower steering wheel boss cover from the steering wheel sub-assembly.