PARKING BRAKE CABLE INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 PARKING BRAKE CABLE CLAMP


    1. A01G3E0

      Engage the 2 claws to install a new No. 1 parking brake cable clamp to the No. 3 parking brake cable assembly.

      Tech Tips

      Even if a one-piece type No. 1 parking brake cable clamp was originally installed, make sure to install a separate type No. 1 parking brake clamp.

  2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A01G2KL

      Insert the No. 3 parking brake cable assembly into the body.

    2. Install the No. 3 parking brake cable assembly with the 5 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    3. Engage the clamp to install the No. 3 parking brake cable assembly.

      Note

      Securely install the clamp.

    4. A01G3KZC02
      *1 Rear Disc Brake Cylinder Assembly
      *a Clip

      Engage the clip to install the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.

      Note

      Be sure to engage the clip to the rear disc brake cylinder assembly as shown in the illustration.

    5. A01G3QT

      Connect the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.

  3. INSTALL PARKING BRAKE LEVER PROTECTOR

    A01G3BE

    1. Install the parking brake lever protector.

  4. INSTALL REAR FLOOR SIDE MEMBER COVER LH (for LH Side)

    Click here

  5. INSTALL REAR FLOOR SIDE MEMBER COVER RH (for RH Side)

    Click here

  6. INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR


    1. Install the front No. 2 floor heat insulator with the 3 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  7. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR


    1. Install the front No. 1 floor heat insulator with the 3 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  8. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  9. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Pass the No. 1 parking brake cable assembly through the parking brake lever sub-assembly.

    2. A01G3UJ

      Bend down the parking brake lever sub-assembly claw.

    3. A01G2J6

      Temporarily install the No. 2 wire adjusting nut to the No. 1 parking brake cable assembly.

  10. INSTALL PARKING BRAKE CABLE END STOPPER


    1. Install the parking brake cable end stopper.

    2. A01G3UA

      Insert the No. 1 parking brake cable assembly into the parking brake equalizer.

    3. A01G3GM

      Push the No. 1 parking brake cable assembly and rotate the cable end 90° to install the No. 1 parking brake cable assembly.

  11. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY

    Click here