BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE


  1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    1. A013ANU

      Install the nut to the brake pedal support assembly.

    2. A013AI8

      Install the brake pedal support assembly with the 4 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }
    3. A013AGR

      Engage the clamp to install the wire harness.

    4. A0139LA

      Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

      Torque:
      23.6 N*m  { 241 kgf*cm, 17 ft.*lbf }

  2. INSTALL PUSH ROD PIN


    1. Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.

    2. A013AR2

      Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal support assembly.

  3. INSTALL BRAKE PEDAL RETURN SPRING


    1. A013B6X

      Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

  4. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

    Click here

  5. INSTALL STOP LIGHT SWITCH ASSEMBLY

    Click here

  6. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

    Click here

  7. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. A013AUF

      Install the instrument panel junction block assembly with the 2 bolts and screw.

    2. Connect the 5 connectors and engage the clamp.

    3. A0139PJ

      Connect the connector to the main body ECU.

    4. Engage the claw to install the wire harness protector to the instrument panel junction block assembly.

  8. INSTALL COMBINATION METER ASSEMBLY

    Click here

  9. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  10. INSPECT AND ADJUST BRAKE PEDAL

    Click here

  11. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

    Click here