FRONT SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    for Wagon: Click here

    for Hatchback: Click here

  3. REMOVE FRONT FENDER LINER

    Tech Tips

    Use the same procedure for the LH side and RH side.

    Click here

  4. REMOVE FRONT SPEED SENSOR


    1. Disengage the clamp (A) from the vehicle body.

      A01KTP0C03
      *a No. 1 Sensor Clamp *b No. 2 Sensor Clamp
      *c Clamp A *d Clamp B
      *e Clamp C - -

    2. Disconnect the connector from the front speed sensor.

    3. Disengage the clamp (B) from the vehicle body.

    4. Remove the bolt (B) and separate the No. 2 sensor clamp from the vehicle body.

    5. Remove the bolt (A) and separate the No. 1 sensor clamp from the front shock absorber assembly.

    6. Disengage the clamp (C) from the front shock absorber assembly.

    7. Remove the bolt (C) and front speed sensor from the steering knuckle.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.