REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE REAR WHEEL

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  5. LOOSEN NO. 2 WIRE ADJUSTING NUT

    Click here

  6. REMOVE PARKING BRAKE LEVER PROTECTOR

    Click here

  7. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  8. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  9. REMOVE REAR DISC

    Click here

  10. DISCONNECT SKID CONTROL SENSOR WIRE


    1. A01KSV5

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note

      Be careful not to damage the rear speed sensor.

  11. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. Remove the rear axle hub and bearing assembly.

      Click here

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.