REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly.

      Click here

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  2. CONNECT SKID CONTROL SENSOR WIRE


    1. Connect the connector to the rear speed sensor.

  3. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  4. INSPECT REAR AXLE HUB RUNOUT

    Click here

  5. INSTALL REAR DISC

    Click here

  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  8. INSTALL PARKING BRAKE LEVER PROTECTOR

    Click here

  9. ADJUST PARKING BRAKE

    Click here

  10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  11. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  12. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

    2. Connect the reservoir level switch connector.

    3. Clear the DTCs.

      Click here

  13. CHECK FOR SPEED SENSOR SIGNAL

    Click here