STOP LIGHT SWITCH INSPECTION

PROCEDURE


  1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    1. A00Y7ADC07
      *a

      Component without harness connected

      (Stop Light Switch Assembly)
      *b Not Pushed
      *c Pushed
      *d Switch Pin

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Switch pin pushed 10 kΩ or higher
      Switch pin not pushed Below 1 Ω
      3 - 4 Switch pin pushed Below 200 Ω
      Switch pin not pushed 10 kΩ or higher

      If the result is not as specified, replace the stop light switch assembly.